9 Fall Crankbait Tricks That Trigger Reaction Strikes
Fall bass have one thing on their minds. Shad. As the water cools out of the 70s, threadfin and gizzard shad leave the main lake and pile into creeks, pockets and wind-blown banks, and the bass go with them.
A crankbait is built for this. It looks like a shad, it covers water fast, and it runs into things. That last part matters most. A bass that won't chase down a meal will still snap at a bait that bounces off a rock and darts sideways in front of its face. That is a reaction strike.
These nine tricks cover the whole fall arc, from water in the upper 60s down to the low 50s. A lot of lakes are in the 50s right now, so each section says how the trick changes as the water gets cold.
1. Hit Something on Purpose
A crankbait swimming through open water gets some bites. A crankbait that crashes into cover gets a lot more.
This is the job a squarebill was made for. The square lip makes baits like the Strike King KVD 1.5 and Lucky Craft LC 1.5 kick out to the side when they hit wood or rock, then right themselves and keep swimming. That sudden change of direction looks like a panicked baitfish.
So don't steer around the laydown. Throw past it and bring the bait right through the limbs. Grind it down a riprap bank. Bump every dock post and stump you can reach.
When the bait loads up against a limb, stop reeling and give it slack. Most squarebills float up and back out on their own. Pulling harder is what buries the hooks.
2. Pause Right After Contact
This is the trick that matters most in late November.
In 65 degree water, a bass will run a deflecting bait down and crush it. In 52 degree water, the same fish often needs an extra beat. Give it one. When the bait ticks a rock or pops free of a limb, stop the handle for one to two seconds, then start again.
A floating crankbait rises slowly on the pause, like a stunned shad. A lot of bites come on that rise or on the first turn of the handle after it. Sometimes the line just goes heavy or jumps sideways.
Stop-and-go works without cover too. Across a bare clay point or a flat, reel five or six turns, pause, and repeat. The colder the water, the longer the pause.
3. Burn It, Then Kill It
Early in the fall, with water still in the 60s, speed is a trigger all by itself. Bass are chasing shad schools and they are used to bait moving fast.
Reel a squarebill or a lipless crankbait as fast as you can for eight or ten turns, then stop it dead. A fish following the bait has to decide the second it stalls, and it usually decides to eat. If nothing hits, burn it again.
This is a great way to cover a shallow flat in the back of a creek when shad are flipping on the surface. A reel in the 7:1 range makes it less work.
Save this one for the warm end of fall. Once the water drops under about 55, lean on the pause in trick 2 instead.
4. Match the Size and Color to the Shad
By fall, a lake is full of shad that hatched this year, and many of them are only two or three inches long. Bass key on that size. A big, wide crankbait can look wrong next to the real thing.
Start with smaller bodies. The 1.0 and 1.5 size squarebills, the Rapala DT6 and the Bandit 200 are all close to the size of a fall shad. If bass spit up bait in the livewell, look at how long it is and match it.
Color follows water clarity and temperature:
- Clear water: natural shad patterns with pearl, gray or translucent sides.
- Stained water: chartreuse with a black or blue back.
- Cooling water, mid-50s and below: crawfish reds and oranges, mostly around rock.
Carry a shad color and a chartreuse color in every bait you throw. That covers most fall days.
5. Pick a Bait That Dives Deeper Than the Water
This one sounds backward until you try it. If you are fishing a flat that is four feet deep, don't tie on a bait that runs three feet. Tie on one that wants to run five or six.
A bait that dives a little deeper than the bottom digs in. It kicks up silt, knocks on rock and stumps, and deflects the whole way back to the boat. A bait that runs above the bottom has nothing to bounce off.
Most crankbaits list their range on the package or in the name. The DT6 is built to dive to six feet, a good pick for banks and flats in four to six feet. Line size matters too. Thinner line lets a bait run deeper, and thicker line holds it up.
The rule breaks over grass, where a digging bait just comes back fouled. There you want to tick the tops, which is where trick 8 comes in.
6. Parallel the Bank Instead of Casting at It
Most anglers park off the bank and cast straight at it. The bait passes through the depth where the fish are for only a few feet of each retrieve, then swims back through empty water.
Turn the boat. Put it tight to the bank and cast along it. If the fish are holding in five feet on a riprap bank, a parallel cast keeps the bait in front of them the entire time.
This pays off best on three kinds of bank in late fall:
- Riprap. Bridges, causeways and dam faces. Rock holds heat, crawfish and shad.
- Bluff walls. Bass can slide up or down a few feet with the weather without moving far.
- Channel-swing banks. Places where the creek channel bends in against the shore. Deep water next to shallow water is where late-fall fish like to live.
Make passes at different distances from the bank. One lane usually gets the bites, and then you can run that same lane down every bank like it.
7. Go Flat and Tight When the Water Drops Below 55
A wide, thumping wobble is great when bass are aggressive. As the water falls through the mid-50s, they tend to respond better to a tight, subtle shimmy.
That is the job of flat-sided and balsa crankbaits. The Rapala Shad Rap is the classic example, a balsa bait with a tight action that has caught cold-water bass for decades. The SPRO Little John is a flat-sided plastic bait in the same family that casts easier in wind.
Fish them slow and steady on rock, clay points and channel-swing banks, with the pause from trick 2 worked in. Light balsa baits are hard to throw on baitcasting gear, so many anglers fish them on a spinning rod with 8 pound line.
On most lakes in late November, this is the crankbait to have tied on. It keeps working into winter, which is why it shows up in our list of cold-water bass baits that outfish everything in winter.
8. Rip a Lipless Crankbait Out of the Grass
If your lake has hydrilla, milfoil or coontail, the grass thins and dies back in late fall. The clumps that stay green hold bait, and bass sit in and around them.
A lipless crankbait like the Bill Lewis Rat-L-Trap is the tool for this. A half-ounce bait covers most situations. Cast over the grass and reel just fast enough to tick the tops. When the bait bogs down, snap the rod hard to rip it free. The bite comes right as the bait bursts out clean.
As the water gets colder, switch to a yo-yo. Let the bait fall to the bottom or the grass on a semi-slack line, lift the rod from nine o'clock to eleven, then let it flutter back down. Most hits come as it drops, so watch your line.
Shad colors and chrome work early. As the water cools into the 50s, red and orange craw patterns get better, and they stay good through winter and into the pre-spawn.
9. Follow the Wind and the Bait to the Back Third
None of these retrieves matter if there are no shad around. Finding the bait is the first job on any fall day.
Through the heart of fall, that usually means the back third of creeks and big pockets. Look for shad flickering on the surface, birds working, or clouds of bait on your electronics. Our guide to following bait from the main lake to the creeks walks through that move step by step.
Wind makes it easier. It pushes plankton against a bank, the shad follow, and the bass follow the shad. It also breaks up the surface so fish can't get a good look at your bait. A windy bank is a crankbait bank. Fish it first.
Late in the fall, things shift. After a few hard cold snaps, bait starts pulling back out toward the creek mouths and deeper channel bends. If the backs feel empty in late November, work your way out, stopping at each channel swing and rocky point until you run into bait again.
Quick Fall Crankbait Setup
Crankbait fish are often barely hooked on small trebles. The whole setup is built around keeping those hooks in.
| Piece | What to use | Why |
|---|---|---|
| Rod | 7 foot to 7 foot 4, medium power, moderate action, glass or composite | The soft bend lets fish take the bait deeper and keeps trebles from tearing out |
| Reel | 6:1 range for most cranking, 7:1 range for burning and lipless baits | A moderate speed keeps you from overworking the bait in cold water |
| Line | 10 to 12 pound fluorocarbon for most baits | Thin line means longer casts and more depth, and fluorocarbon sinks |
| Heavy cover or grass | 15 to 17 pound fluorocarbon | Stands up to wood and helps rip a lipless bait free of grass |
Make long casts. A crankbait needs distance to reach its depth and stay there. Our breakdown of braid, fluorocarbon and mono covers when each line makes sense.
Check your hooks too. Grinding rock dulls trebles fast. If a point will not catch on your thumbnail, swap in a new hook of the same size.
Frequently Asked Questions
What is the best crankbait for bass in the fall? A 1.5 size squarebill in a shad pattern is the best all-around pick while the water is in the 60s, because it deflects well off shallow wood and rock. Once the water falls below about 55 degrees, a tight-wobbling flat-sided or balsa bait like the Rapala Shad Rap usually gets more bites.
What water temperature is best for crankbait fishing in the fall? Crankbaits work through the whole fall, from the low 70s down to about 50 degrees. Fast retrieves and squarebills are strongest from roughly 60 to 70 degrees, and slower retrieves with tight-wobble baits and lipless crankbaits take over from about 50 to 58.
What color crankbait should I use in the fall? Use natural shad patterns in clear water and chartreuse with a black back in stained water. When the water drops into the mid-50s and below, add crawfish reds and oranges, mostly around rock and dying grass.
How fast should I reel a crankbait in cold water? Slow and steady, with pauses. In water below 55 degrees, reel just fast enough to feel the bait wobble, and stop it for one to two seconds every time it hits something. Save the fast burn-and-kill retrieve for water above 60.
What pound test line is best for crankbaits? Use 10 to 12 pound fluorocarbon for most crankbait fishing, since thinner line casts farther and lets the bait dive deeper. Step up to 15 to 17 pound around heavy wood or grass, and drop to about 8 pound on spinning gear for light balsa baits.
Go Run Into Something
Find the shad, pick a bait that reaches the bottom, and make it hit things. Then let the water temperature set your speed. Fast and erratic in the 60s. Slow, tight and full of pauses in the low 50s.
Before you hook up the boat, check the weekly fishing reports for your lake to see where the water temperature sits.
- #listicle
- #crankbait
- #fall bass fishing
- #squarebill
- #lipless crankbait
- #reaction strikes
- #shad migration
- #riprap
- #cold water bass
- #largemouth bass
- #late fall
